Factors Causing Low Capacity Of Vertical Mill

2020-06-20

The complete configuration of vertical mill includes crusher, bucket elevator, storage bin, vibrating feeder, main unit of vertical mill, frequency conversion classifier, double cyclone powder collector, pulse dust removal system, high pressure fan, Air compressor, electrical control system.

There are many factors that affect the production capacity of the vertical mill in the production work, so the output is different, sometimes the output is high, sometimes the output is low. So why is this happening? Today, this article interviewed the relevant R&D experts of Shanghai Zenith Mill, and listened to how they talked about it!

First, the hardness of the material. Everyone knows that the harder the material, the more difficult it is to grind and crush. And the material is too hard will cause serious damage to the body of the mill, vertical mill grinding roller grinding ring is relatively easy to wear.

Secondly, the humidity and viscosity of the material. In general, when the material is too wet or too sticky, it is not conducive to crushing. When the moisture content of the material is large and the viscosity is high, the material is easy to stick to the machine, causing blockage in the cutting and conveying process, affecting the production output of the vertical mill equipment.

Again, the fineness of the material. The finer the material, the easier it is to stick to the machine, causing blockage, affecting the output of the mill, and increasing the energy consumption of the mill. Therefore, when there is too much subdivision content, it should be screened once in advance.

Then, the fineness requirements of the finished material. Some customers will have higher requirements for the fineness of finished materials. However, the higher the fineness requirement, the production capacity of the vertical mill equipment is bound to be reduced, and the two are in an inverse relationship.

Finally, the quality requirements of the mill. For different materials, we need to choose different mill equipment, because the milling conditions of some mills do not meet the requirements. If this mill is used, it will result in reduced production and damage to the mill. Case. At the same time, the materials used during the casting of the grinding parts of the mill also affect the hardness of the material that the mill can grind. If it exceeds the hardness that can be ground, it will cause significant damage to the grinding ring of the vertical mill. It is difficult to meet the production needs of customers.

Therefore, when we choose the vertical mill, we must choose the exact series and model, so that we can meet the production needs of users. Manufacturers with milling needs can contact our Keli Ruike, we produce different series of mills such as Raymond mill, high-pressure mill, ultra-fine mill, vertical mill, etc., for different users can choose more accurate equipment.