3 Tips To Better Maintain Your Raymond Mill

2022-12-02

Maintenance Method Of Raymond Mill

1. When the Raymond mill is running, it must be supervised by someone. During use, the operator must have relevant information and operational skills. To understand the principle and performance of the Raymond mill, familiar with the operating procedures.

2. In order to achieve normal operation of mill, equipment maintenance and safe operation system should be formulated to ensure the long-term safe operation of the mill, and the necessary maintenance tools, grease and corresponding accessories should be provided at the same time.

3. Regular maintenance. After using for a period of time, Raymond mills should be overhauled, especially those vulnerable parts, grinding rollers, grinding rings, blades and other accessories should be under maintenance management.

4. When the roller device is used for more than 500 hours, the rollers should be replaced, the rolling bearings in the roller sleeve must be cleaned, and the damaged parts should be replaced in time.

How To Start Raymond Mill

The first is before Raymond mill starts. The relevant operator should check whether all access doors are closed tightly. Check whether the feed port of the equipment meets the size of the feed particle size, and adjust the speed of the analyzer to approximately the finished product particle size. When everything is ready, start the device normally in the following order. The starting point for starting the device is to start the device without load, The device can only be fed after the device is stable.

The correct boot sequence is: bucket elevator – crusher – analyzer – blower (empty load start, after the equipment is normal operation and then load) – Raymond mills the host.

How To Correct Shutdown

Stop the feeder first to stop feeding; stop the host about one minute later; blow the remaining powder and stop the blower; finally turn off the analyzer.

In the Raymond mill operating procedures, when Raymond grinding mill is used for a period of time, it is necessary to perform overhaul. The maintenance personnel will wear the worn parts such as grinding roller ring blade. The degree of comprehensive assessment, if you need to replace it should be promptly replaced. In addition, they will also carefully check the stability of the bolts and nuts. After the inspection, the tightened parts should be tightened immediately and then greased.